4D LearningFRC 6429 4th Dimension

Arduino deneyi 03

Button-Controlled LED

Beginner · 40 min · Digital input

Read a push button and use it to control an LED.

Sesli anlatım videosu (İngilizce, sentetik ses). Çekim videosu eklenince yerini alır.

Malzemeler

  • Arduino Uno
  • Push button
  • LED
  • 220 Ω resistor
  • 10 kΩ resistor
  • Breadboard and jumper wires

Bağlantı

  1. Connect one side of the button to 5V and the other to pin 2.
  2. Connect a 10 kΩ pull-down resistor between pin 2 and GND.
  3. Connect pin 13 through 220 Ω to the LED anode; connect the cathode to GND.

Kod

const int buttonPin = 2;
const int ledPin = 13;

void setup() {
  pinMode(buttonPin, INPUT);
  pinMode(ledPin, OUTPUT);
}

void loop() {
  digitalWrite(ledPin, digitalRead(buttonPin));
}

Ne olmalı?

The LED lights while the button is pressed.

Meydan okuma

Change the circuit and code to use INPUT_PULLUP.

Güvenlik ve sorun giderme

  • Bağlantıyı değiştirmeden önce gücü kes.
  • Her LED ile direnç kullan.
  • Kart ve port seçimini Arduino IDE'de kontrol et.
  • Her kablonun koddaki pin numarasıyla eşleştiğini doğrula.

Not: Ders metinleri İngilizcedir. Orijinal Türkçe çalışma kâğıdı PDF olarak indirilebilir.