4D LearningFRC 6429 4th Dimension

Arduino deneyi 11

Ultrasonic Distance Meter

Intermediate · 55 min · Time of flight

Measure distance with an HC-SR04 and alert when an object comes close.

Sesli anlatım videosu (İngilizce, sentetik ses). Çekim videosu eklenince yerini alır.

Malzemeler

  • Arduino Uno
  • HC-SR04 ultrasonic sensor
  • LED
  • 220 Ω resistor
  • Breadboard and jumper wires

Bağlantı

  1. Connect HC-SR04 VCC to 5V, GND to GND, Trig to pin 7 and Echo to pin 6.
  2. Connect pin 13 through 220 Ω to the LED anode and its cathode to GND.

Kod

const int trigPin = 7, echoPin = 6, ledPin = 13;

void setup() {
  pinMode(trigPin, OUTPUT); pinMode(echoPin, INPUT); pinMode(ledPin, OUTPUT);
  Serial.begin(9600);
}

void loop() {
  digitalWrite(trigPin, LOW); delayMicroseconds(2);
  digitalWrite(trigPin, HIGH); delayMicroseconds(10); digitalWrite(trigPin, LOW);
  long duration = pulseIn(echoPin, HIGH, 30000);
  float distance = duration * 0.0343 / 2.0;
  Serial.println(distance);
  digitalWrite(ledPin, duration > 0 && distance < 20 ? HIGH : LOW);
  delay(100);
}

Ne olmalı?

Distance appears in centimetres and the LED turns on below 20 cm.

Meydan okuma

Make the LED blink faster as an object gets closer.

Güvenlik ve sorun giderme

  • Bağlantıyı değiştirmeden önce gücü kes.
  • Her LED ile direnç kullan.
  • Kart ve port seçimini Arduino IDE'de kontrol et.
  • Her kablonun koddaki pin numarasıyla eşleştiğini doğrula.

Not: Ders metinleri İngilizcedir. Orijinal Türkçe çalışma kâğıdı PDF olarak indirilebilir.