4D LearningFRC 6429 4th Dimension

Arduino deneyi 14

Potentiometer LED Dimmer

Beginner · 40 min · Analog-to-PWM mapping

Turn a potentiometer to control LED brightness.

Sesli anlatım videosu (İngilizce, sentetik ses). Çekim videosu eklenince yerini alır.

Malzemeler

  • Arduino Uno
  • 10 kΩ potentiometer
  • LED
  • 220 Ω resistor
  • Breadboard and jumper wires

Bağlantı

  1. Connect the potentiometer outer pins to 5V and GND; connect its centre pin to A0.
  2. Connect PWM pin 9 through 220 Ω to the LED anode and the cathode to GND.

Kod

const int potPin = A0, ledPin = 9;

void setup() { pinMode(ledPin, OUTPUT); }

void loop() {
  int reading = analogRead(potPin);
  int brightness = map(reading, 0, 1023, 0, 255);
  analogWrite(ledPin, brightness);
}

Ne olmalı?

LED brightness changes smoothly as the knob turns.

Meydan okuma

Reverse the response so clockwise movement makes the LED dimmer.

Güvenlik ve sorun giderme

  • Bağlantıyı değiştirmeden önce gücü kes.
  • Her LED ile direnç kullan.
  • Kart ve port seçimini Arduino IDE'de kontrol et.
  • Her kablonun koddaki pin numarasıyla eşleştiğini doğrula.

Not: Ders metinleri İngilizcedir. Orijinal Türkçe çalışma kâğıdı PDF olarak indirilebilir.