4D LearningFRC 6429 4th Dimension

Arduino deneyi 16

Joystick Servo Control

Intermediate · 50 min · Input mapping

Use a joystick’s horizontal axis to position a servo from 0° to 180°.

Sesli anlatım videosu (İngilizce, sentetik ses). Çekim videosu eklenince yerini alır.

Malzemeler

  • Arduino Uno
  • 2-axis joystick module
  • SG90 micro servo
  • Jumper wires
  • External regulated 5V supply recommended

Bağlantı

  1. Connect joystick VCC to 5V, GND to GND and VRx to A0.
  2. Connect servo signal to pin 9 and its power to regulated 5V.
  3. Join external supply GND to Arduino GND.

Kod

#include <Servo.h>
Servo arm;
const int joyX = A0;

void setup() { arm.attach(9); }

void loop() {
  int reading = analogRead(joyX);
  int angle = map(reading, 0, 1023, 0, 180);
  arm.write(angle);
  delay(15);
}

Ne olmalı?

The servo follows horizontal joystick movement.

Meydan okuma

Add a small dead zone around the joystick centre to reduce jitter.

Güvenlik ve sorun giderme

  • Bağlantıyı değiştirmeden önce gücü kes.
  • Her LED ile direnç kullan.
  • Kart ve port seçimini Arduino IDE'de kontrol et.
  • Her kablonun koddaki pin numarasıyla eşleştiğini doğrula.

Not: Ders metinleri İngilizcedir. Orijinal Türkçe çalışma kâğıdı PDF olarak indirilebilir.