Arduino deneyi 18
PIR Motion Alarm
Intermediate · 45 min · Motion sensing
Detect movement with a PIR sensor and trigger a small buzzer or LED.
Malzemeler
- Arduino Uno
- PIR motion sensor
- Active 5V buzzer or LED with 220 Ω resistor
- Jumper wires
Bağlantı
- Connect PIR VCC to 5V, GND to GND and OUT to pin 2.
- Connect a low-current active buzzer to pin 8 and GND, or use an LED with a resistor.
Kod
const int pirPin = 2, alarmPin = 8;
void setup() {
pinMode(pirPin, INPUT); pinMode(alarmPin, OUTPUT);
Serial.begin(9600);
}
void loop() {
bool motion = digitalRead(pirPin);
digitalWrite(alarmPin, motion);
if (motion) Serial.println("Motion detected");
delay(100);
}
Ne olmalı?
After its warm-up period, the PIR activates the output when movement is detected.
Meydan okuma
Keep the alarm active for five seconds after the last movement.
Güvenlik ve sorun giderme
- Bağlantıyı değiştirmeden önce gücü kes.
- Her LED ile direnç kullan.
- Kart ve port seçimini Arduino IDE'de kontrol et.
- Her kablonun koddaki pin numarasıyla eşleştiğini doğrula.
Not: Ders metinleri İngilizcedir. Orijinal Türkçe çalışma kâğıdı PDF olarak indirilebilir.
