4D LearningFRC 6429 4th Dimension

Arduino deneyi 04

LDR Light Sensor

Beginner · 45 min · Analog input

Measure light with a photoresistor and switch on an LED when the room gets dark.

Sesli anlatım videosu (İngilizce, sentetik ses). Çekim videosu eklenince yerini alır.

Malzemeler

  • Arduino Uno
  • LDR/photoresistor
  • 10 kΩ resistor
  • LED
  • 220 Ω resistor
  • Breadboard and jumper wires

Bağlantı

  1. Make a voltage divider: 5V → LDR → A0 → 10 kΩ → GND.
  2. Connect pin 13 through 220 Ω to the LED anode and its cathode to GND.

Kod

const int ldrPin = A0;
const int ledPin = 13;
const int threshold = 400;

void setup() {
  pinMode(ledPin, OUTPUT);
  Serial.begin(9600);
}

void loop() {
  int light = analogRead(ldrPin);
  Serial.println(light);
  digitalWrite(ledPin, light < threshold ? HIGH : LOW);
  delay(100);
}

Ne olmalı?

The Serial Monitor shows light readings and the LED switches on below the threshold.

Meydan okuma

Observe your room’s values and calibrate the threshold.

Güvenlik ve sorun giderme

  • Bağlantıyı değiştirmeden önce gücü kes.
  • Her LED ile direnç kullan.
  • Kart ve port seçimini Arduino IDE'de kontrol et.
  • Her kablonun koddaki pin numarasıyla eşleştiğini doğrula.

Not: Ders metinleri İngilizcedir. Orijinal Türkçe çalışma kâğıdı PDF olarak indirilebilir.