Arduino deneyi 17
Automatic Fan Controller
Intermediate · 65 min · Threshold control
Switch a small DC fan on automatically when a DHT11 reports high temperature.
Malzemeler
- Arduino Uno
- DHT11 module
- Logic-level N-channel MOSFET
- Small DC fan
- Flyback diode
- 10 kΩ gate pull-down
- External fan supply
Bağlantı
- Connect DHT11 DATA to pin 4.
- Drive the MOSFET gate from pin 6; add 10 kΩ from gate to GND.
- Connect fan through the MOSFET and external supply; place the diode reverse-biased across the fan.
- Join external supply and Arduino grounds.
Kod
#include <DHT.h>
#define DHTPIN 4
#define DHTTYPE DHT11
DHT dht(DHTPIN, DHTTYPE);
const int fanPin = 6;
const float threshold = 28.0;
void setup() { pinMode(fanPin, OUTPUT); dht.begin(); }
void loop() {
float temperature = dht.readTemperature();
if (!isnan(temperature)) digitalWrite(fanPin, temperature >= threshold);
delay(2000);
}
Ne olmalı?
The fan starts at or above 28 °C and stops below it.
Meydan okuma
Add a second, lower off-threshold to prevent rapid switching.
Güvenlik ve sorun giderme
- Bağlantıyı değiştirmeden önce gücü kes.
- Her LED ile direnç kullan.
- Kart ve port seçimini Arduino IDE'de kontrol et.
- Her kablonun koddaki pin numarasıyla eşleştiğini doğrula.
Not: Ders metinleri İngilizcedir. Orijinal Türkçe çalışma kâğıdı PDF olarak indirilebilir.
